How to Choose Cold Heading Dies for Stainless Steel Fasteners
Stainless steel work hardens quickly and tends to gall. Here is how die material, cavity geometry and coating selection affect tool life and part quality.
Stainless steel behaves very differently from carbon steel in a cold heading machine. It work hardens fast, has higher friction against tool surfaces and is prone to galling. A die that performs well on low-carbon wire can fail within a few thousand strokes on A2 or A4 stainless.
Start with the die material. For moderate volumes, a high-toughness tool steel with a properly controlled heat treatment gives the best balance between cost and resistance to chipping. For long runs or abrasive conditions, a tungsten carbide insert in a shrunk steel case keeps the cavity dimension stable and dramatically reduces wear. The case must be designed for the interference fit and the expected forming load, not simply copied from a carbon-steel tool.
Next, look at the cavity geometry. The entry radius, bearing length and relief angle all influence how the material flows. A generous entry radius reduces the peak forming load, while the right bearing length stabilises the head diameter without generating excessive heat. On stainless parts, we generally shorten the bearing slightly and improve surface finish to keep friction low.
Coating is the third lever. TiN is a cost-effective general choice, TiCN offers higher surface hardness for abrasive stainless grades, and TiAlN performs better when the tool runs hot at high stroke rates. A DLC coating can help when galling is the dominant failure mode. Coating only helps when the substrate underneath is hard and correctly ground, so it should never be used to compensate for an underspecified die body.
Finally, plan for inspection and iteration. Ask your supplier for dimensional and hardness reports, and treat the first trial run as data: measure the parts, note where wear appears and adjust the geometry before ordering the full tool set. Small-batch trial tooling is usually cheaper than a full production set that has to be reworked.
Need help choosing the right tooling?
Send your part drawing and our engineers will recommend the die material, geometry and coating.
Request a Quote